Blacksmith's tip: there are some ways undertake it ! mark your steel when you start measuring to a cut. One solution is to get your steel ruler on your face of the anvil aligned with the trunk edge and measure out of the desired length of the steel. Then, using the sharp edge of the back of your anvil, may get lightly mark your desired measurement by striking the steel against that edge with a hammer. Also . a visible dent you should be capable of finding easily despite if heating to an orange warmness. Another method Slate roof Fascia For aesthetic appeal marking is using something called "Soap Stone". It can be a stone is definitely naturally soft, leaves a clearly visible white mark (almost like chalk) against a steel surface, and is very proofed against heat. This mark will remain quite visible even after enduring high temperatures on forge fire-starters.
Look in the big picture.
